I get the same library error on ESP2866-12E example, fix?

I saw the same error message on your page:

Invalid library found in C:\Program Files (x86)\Arduino\libraries\Arduino-master: C:\Program Files (x86)\Arduino\libraries\Arduino-master

This message was seen when uploading. Normally, I don't expect to see compile/link errors after I've successfully compiled (verified). So yeah, that's what I think I said.

I resolved it. I can compile. I cannot upload blink to Geekcreit 'DOIT' development kit V3 12F. 12F is supposed to be almost identical to 12E (just ant update?).

Correct port (I can talk to another 12E direct from Banggood). I believe I talked to the chip before attempting to program.

USB connects to PC.

NodeMCH 1.0 selected under board.

I've been programming WeMOS 1D boards successfully.

Ideas?

2 Replies

Know the answer? Post it — somebody with the same question will find it here.

Alan Marconett8y ago
I saw the same error message on your page:
Invalid library found in C:\Program Files (x86)\Arduino\libraries\Arduino-master: C:\Program Files (x86)\Arduino\libraries\Arduino-master

This message was seen when uploading. Normally, I don't expect to see compile/link errors after I've successfully compiled (verified). So yeah, that's what I think I said.

I resolved it. I can compile. I cannot upload blink to Geekcreit 'DOIT' development kit V3 12F. 12F is supposed to be almost identical to 12E (just ant update?).

Correct port (I can talk to another 12E direct from Banggood). I believe I talked to the chip before attempting to program.

USB connects to PC.

NodeMCH 1.0 selected under board.

I've been programming WeMOS 1D boards successfully.

Ideas?
+1
Nilesh Shah8y ago
Read your question again.

Is it meaningful at all?
+1